EMT Practice Test

1. Question Content...

---

Question1: Current enterprise networks usually use OSPF as the routing protocol.
What precautions are there when OSPF is used? (Choose four.)

Question2: When communicating with customers, Huawei engineers need to be groomed, well behaved, and appropriate in language use.

Question3: During the migration test, which of the following indicates that the test is completed?

Question4: To rectify a VRRP group two-master fault, run the display this command on VLANIF interfaces on both ends of the VRRP group.
Which of the following operations is not performed?

Question5: Switches run the MSTP protocol by default. Which of the following statements regarding the default status is true?

Question6: The migration rollback time can be determined based on the actual migration situation, without the need to plan in advance.

Question7: Ethernet is the most mainstream LAN. Which of the following factors should be considered in Ethernet type selection? (Choose two.)

Question8: When a Huawei router serves as an SSH client and attempts to log in to another Huawei router, the login fails. It is suspected that the SSH server configuration is incorrect.
Which of the following causes is the most impossible for the server fault?

Question9: During unpacking and inspection, the device appearance is intact and all modules work properly after the first power-on. After the device continuously runs for 24 hours, a fault occurs on a card. This situation does not conform to DOA conditions.

Question10: Currently, to which of the following modes does network design conform?

Question11: Generally, which of the following enterprise services require user experience optimization?

Question12: Employees in an enterprise often need to connect to the enterprise's intranet for remote access when going on business.
Which of the following technologies can meet this demand? (Choose two.)

Question13: Which of the following are migration difficulties? (Choose three.)

Question14: Which of the following work is not prepared before the migration?

Question15: During EBGP peer relationship troubleshooting, it is found that two directly connected devices set up connections using loopback interfaces. Therefore, the display current-configuration configuration bgp command is executed to check the configuration of peer ebgp-max-hop hop-count.
Which of the following statements is correct?

Question16: Which of the following features is not applied to enterprise WANs?

Question17: Which of the following aspects should be considered for migration risk assessment?

Question18: Access control is used to limit the traffic rate or block specific traffic based on reachable network routes to meet service management and control needs.

Question19: The project scope can be determined from three aspects. Which of the following is not included?

Question20: Which of the following routers provides the cluster function?

Question21: Which of the following aspects should be considered during preliminary analysis of a migration project?
(Choose three.)

Question22: Which of the following networks are involved during construction of a large enterprise network?

Question23: Which of the following operations are performed during migration acceptance? (Choose three.)

Question24: During MSTP troubleshooting, the display current-configuration command is executed to obtain the configuration file of the device.
Which of the following statements is false?

Question25: Which of the following fiber interface types is usually used on the device side?

Question26: Which of the following causes may result in an IS-IS neighbor relationship fault?

Question27: The display interface brief command can be executed to check the interface status. When sent and received traffic exceeds 70%, it can be determined that the traffic volume is high.

Question28: Data center switches greatly differ from campus switches.
Which of the following features are specific to data center switches but are not supported by campus switches?